Shanghai Kent flowmeter manual | How to read flowmeter flow rate

『Shanghai Kent flowmeter manual』Related information(clamp on meter|electromagnetic meter|venturi meterrotameter|orifice meter|ultrasonic flow meter|mass flow meter|coriolis mass flow meter|coriolis flow meter|magnetic flow meter|magmeter flow meter|magflow flow meter|mag meter flow meter|electromagnetic flow meter|vortex flow meter|turbine flow meter|thermal mass flow meter|thermal flow meter|rotameter flow meter)

1. GF flowmeter settings

GF flowmeter settings mainly include flow calibration (K coefficient setting), unit adjustment, 4-20mA range setting, and other parameter settings. 1. Flow calibration (K coefficient setting) The K value is a key parameter that represents the conversion coefficient of the flowmeter and directly affects the accuracy of the measurement results. When setting the K value, it is necessary to refer to the user manual and relevant technical information of the flowmeter, and select the appropriate K value based on the model and specifications of the flowmeter, as well as the type and state of the fluid to be measured (such as liquid, gas, temperature, pressure, etc.). The calculated or selected K value can be input into the flow meters settings interface through the flow meters control panel or specialized configuration software. On the GF 9900 transmitter, press and hold the Enter key for 3 seconds, then select CAL and press Enter to enter. Adjust the KF value by right clicking in the direction until it matches the calculated K coefficient. Finally, press Enter to save the settings. 2. Unit adjustment: Choose the appropriate flow unit according to actual needs, such as cubic meters per hour (m ³/h), liters per minute (L/min), gallons per minute (GPM), etc. On the GF 9900 transmitter, the specific steps for unit adjustment are: press and hold the Enter key for 3 seconds, then select INPUT to enter, and then use the directional keys to select and modify the flow unit

3. 4-20mA range setting. Set the range corresponding to 4mA and 20mA according to actual needs

4. Other parameter settings include the selection of instantaneous flow and cumulative flow, alarm and output settings (such

2. Instructions for using a flowmeter

A flowmeter is a tool used to measure the flow velocity of liquids or gases.

1. Confirm the type of flowmeter: Common flowmeters include Sun Yanzhi vortex street flowmeter, electromagnetic flowmeter, blade flowmeter, etc. 2. Install the flowmeter: Install the flowmeter inside the fluid pipeline system, paying attention to the installation position and direction to ensure that the fluid can flow through the flowmeter correctly and that the fluid flow rate inside the flowmeter is uniform and stable. 3. Connect the power supply and output signal: Connect the flowmeter to the power port and connect the signal output line to the display terminal or other monitoring instrument. 4. Calibrate the flowmeter: Calibrate the flowmeter according to the user manual to ensure the accuracy of the reading. 5. Real time monitoring: Start the flow system, turn on the liquid or gas flow, observe and record the flowmeter reading to detect the flow rate. Characteristics of changes and fluid flow. During the monitoring process, it is necessary to constantly monitor real-time data to ensure safe operation an

『SILVER Official Website SERVICE』