『Wiring of split type electromagnetic flowmeter』Related information(clamp on meter|electromagnetic meter|venturi meterrotameter|orifice meter|ultrasonic flow meter|mass flow meter|coriolis mass flow meter|coriolis flow meter|magnetic flow meter|magmeter flow meter|magflow flow meter|mag meter flow meter|electromagnetic flow meter|vortex flow meter|turbine flow meter|thermal mass flow meter|thermal flow meter|rotameter flow meter)
1. What is the wiring diagram of the flowmeter? How is the flowmeter wired? The wiring method of the flowmeter may vary depending on the type and brand. Here are two common wiring methods for flow meters for your reference.
1. Wiring method for split type flow meters: As shown in the above figure, the sensor and accumulator of the split type flow meter are installed separately and connected through signal cables. When wiring, it is necessary to connect the output signal of the sensor to the input terminal of the integrator. Generally speaking, the wiring method of a split type flowmeter is relatively simple. Simply connect the corresponding signal line to the integrator.
2. Wiring method of an integral flowmeter: As shown in the diagram, the integral flowmeter integrates the sensor and integrator together without the need for signal cables.
. When wiring, it is necessary to connect the output signal of the sensors dead end finger to the input terminal of the integrator. The wiring method of the integral flowmeter is relatively simple, just connect the corresponding signal line to the accumulator. It should be noted that different types of flow meters have different wiring methods, so it is necessary to carefully read the user manual of the flow meter before wiring to understand the correct wiring method. At the same time, safety should be taken into account during the wiring process to avoid contact with live parts or dangerous operations.2. Wiring and precautions of electromagnetic flowmeter
Wiring and precautions of electromagnetic flowmeter
1. Wiring and power supply of electromagnetic flowmeter. After the installation of the split type electromagnetic flowmeter, first connect
_600x400.jpg)
2. Precautions for wiring of electromagnetic flowmeter: Before wiring, it is necessary to confirm that the voltage and frequency of the power supply match the rated voltage and frequency of the electromagnetic flowmeter to avoid equipment damage or inaccurate measurement.
. Before turning off the power and wiring, it is necessary to ensure that the power has been turned off to prevent electric shock or equipment damage. During the wiring process, electrical safety regulations should be strictly followed and necessary protective equipment should be worn. The selection and laying of signal cables for electromagnetic flow meters must be strictly separated from other power sources, and cannot be laid in the same pipe, nor can they be laid equally or twisted t
Hot Blog
Related AD
